28191-3-0611 Page 13
A black hood and trim kit is furnished with each model
Attention: The hood is located behind top louver during shipment
1. To remove top louver, lift louver and pull forward.
2. Open bottom louver.
(4) Phillips screws through bottom and top clearance hole on
Figure 9.
the (3) clearance holes in the trim top downward. Align the (3)
clearance holes with the (3) screw holes in the top, interior
7. Close bottom louver.
8. Replace top louver
Figure 9
Finishing
All joints (top, bottom and sides), where the wall or decorative facing
with a non-combustible material.
Hearth extensions are recommended, not a requirement for these
determine where the unit is to be installed and whether optional
accessories are desired. Gas supply piping should also be planned
at this time.
2. A raised platform of combustible or non-combustible material.
perimeter edges on the bottom of the unit.
(Example: Four (4) concrete masonry blocks.)
If the fireplace is installed directly on carpeting, tile or other
on a metal or wood panel extending the full width and depth of the
unit.
At this point, you should have decided what components to include
has not been done, stop and consult your dealer for assistance
with this planning.
INSTALLING HOOD AND TRIM KIT
PLANNING INSTALLATION
Comments to this Manuals