Empire Comfort Systems OLP42FP72S-2 Owner's Manual Page 13

  • Download
  • Add to my manuals
  • Print
  • Page
    / 24
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 12
32274-8-0115 Page 13
FIREPLACE FRAMING AND INSTALLATION
Figure 12
Alternate Framing and Installation Method
1. Installangesonsideofreplaceasshownusingholeson
sideofrebox.SeeFigure9.Themiddlepairofholesiffor
the 1/2 inch non-combustible board provided with the unit.
2. Connect the side framing studs to the top stud as shown in
Figure 13. The channel of the studs should face inward.
The replace is designed to accept a 3/8-inch gas line for an
approvedventlessgaslogset.Havethelineinstalledbyaqualied
service person in accordance with all building codes. Consult local
building codes to properly size the gas supply line leading to the 3/8-
inchhook-upattheunit.ThestateofMassachusettsrequiresthat
aexibleapplianceconnectorcannotexceedthreefeetinlength.
Aex-lineandshut-offvalvehavebeenprovided.The gas shut-off
valve must be located outside of the unit in an accessible area.
Checkgastype.Useonlythe gastypeindicatedonthegaslog
set rating plate. If the gas listed on the plate is not your type of gas
supply, DO NOT INSTALL. Contact your dealer for proper model.
AlwaysuseanexternalregulatorforallLPreplacestoreducethe
supplytankpressuretoamaximumof14"w.c.Thisisinaddition
totheregulatorttedtothelogset.
WARNING: CONNECTION DIRECTLY TO AN UNREGULATED
L.P. TANK CAN CAUSE EXPLOSION.
Install only a ANSI Z21.97.1/CSA 2.41 ventless log set into this
replace.
GAS LINE CONNECTION
Figure 13
3. Connecttheframingstudstotheangesusingfour#10pan-
head screws.
Note: If using a drain tray, the bottom of the side framing studs
willbeapproximately1”fromthebottomoftherebox.
4. Locatethemiddlebracket.Loosenthescrewinthemiddle
topofthereplace.Slidethebracketunderthescrewas
shown in Figure 11. Tighten the hex-head screws on the
replacesecureapan-headscrewthroughthemiddle
bracketandintothetopstud.
5. Locate the two non-combustible boards and place them
abovethereplaceasshowninFigure12.Attachthe
non-combustibleboardtothestudswithsix10-16athead
screws.
6. Securethenon-combustibleboardtothemiddlebracket
usingtwo10-16atheadscrewsasshowninFigure12.
7. Movethereplaceintoposition.Connectthegaslinetothe
unitandcheckforleakswithasoapywatersolution.
Note: Ensure that the gas shut-off valve is accessible.
8. Securereplacetoframingoroor.
Page view 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Comments to this Manuals

No comments